Mitsubishi Electric Mr.SLIM PEAD-A09AA8 Manuel D'utilisation page 5

2. Parts Names
■ Wireless Remote-Controller
* For explanation purposes, all of the items that
appear in the display are shown.
* All items are displayed when the Reset but-
ton is pressed.
Fan Speed button (Changes fan speed)
Airflow button (Changes up/down airflow direction)
Mode button (Changes operation mode)
Note (Only for wireless remote controller):
■ When using the wireless remote controller, point it towards the receiver on the indoor unit.
■ If the remote controller is operated within approximately 2 minutes after power is supplied to the
indoor unit, the indoor unit may beep twice as the unit is performing the initial automatic check.
■ The indoor unit beeps to confirm that the signal transmitted from the remote controller has been
received. Signals can be received up to approximately 7 meters, 275-19/32 inch in a direct line
from the indoor unit in an area 45° to the left and right of the unit. However, illumination such as
fluorescent lights and strong light can affect the ability of the indoor unit to receive signals.
■ If the operation lamp near the receiver on the indoor unit is blinking, the unit needs to be inspected.
Consult your dealer for service.
■ Handle the remote controller carefully! Do not drop the remote controller or subject it to strong
shocks. In addition, do not get the remote controller wet or leave it in a location with high humidity.
■ To avoid misplacing the remote controller, install the holder included with the remote controller on
a wall and be sure to always place the remote controller in the holder after use.
■ Outdoor unit
Remote controller display
ON/OFF button
Set Temperature buttons
Check button
Test Run button
Service Panel
Transmission area
Transmission indicator
Timer indicator
Operation areas
Timer Off button
Timer On button
Hour button
Minute button
Set Time button (Sets the time)
Louver button (Changes left/right airflow direction)
Reset button
Power
Ref. Pipes
Indoor-Outdoor
Connection wire
Earth
Battery installation/replacement
1. Remove the top cover, insert 2 AAA batteries,
and then install the top cover.
1
2
3
Top cover
Two AAA batteries
Insert the negative (–)
end of each battery first.
Install the batteries in the
correct directions
(+, –) !
2. Press the Reset button.
Press the Reset button
with an object that has a
narrow end.
5