Publicité
Les langues disponibles
Les langues disponibles
12
UK
ELECTRICAL CONNECTIONS: FASTONS
Position
1
2
3
ELECTRICAL CONNECTIONS: TERMINAL BOARDS
Terminal
Position
1
2
3
4
M1
5
6
7
8
9
10
11
M2
12
13
14
15
16
17
M3
18
19
22
M5
23
PROTECTION FUSES
Position
Value
315 mA
F1
F2
5 A
F3
500 mA
Description
Signal
Transformer 0 Vac connection (black cable).
0 Vac
Transformer 18 Vac connection (orange cable).
18 Vac
Transformer 24 Vac connection (red cable).
24 Vac
Signal
Description
0 Vac
0 Vac output to the BATTERY CHARGER BOARD.
+24 Vac
24 Vac output to the BATTERY CHARGER BOARD.
Positive connection to the BATTERY CHARGER BOARD.
+SK BAT
Negative connection to the BATTERY CHARGER BOARD.
-SK BAT
Flashlight output 24V 10W max (slow flashing during opening, off with gate open, fast
LAMP
flashing during closing); it can also be connected to the battery charger board.
Warning light output 24V 3W max (slow flashing during opening, on fixed with gate
SPIA
open, fast flashing during closing).
Common INPUTS - OUTPUTS.
COM
Not used.
OPT
STOP
STOP input (N.C.). If not used, jumper with terminal 14.
START input (N.O.).
START
PEDESTRIAN input (N.O.).
PED
PHOTOCELL input (N.C.). If not used, jumper with terminal 14.
PHOTO
SAFETY DEVICE input (N.C.). If not used, jumper with terminal 14 and set DIP 4 to OFF.
SAFETY
Common INPUTS - OUTPUTS.
COM
24V motor output - open.
MOTOR OPEN
24V motor output - close.
MOTOR CLOSE
+ ACCES
+24 Vdc external accessory power supply (photocells, radio, etc.).
24 Vdc power supply for external safety devices (frame), active only during the
operating cycle; connect the devices on which to run the safety test to this input (also
+ SAFETY
see DIP 4).
COM
Common INPUTS - OUTPUTS.
GND
NTENNA BRAID input.
ANTENNA SIGNAL input.
ANT
Type
Description
FAST-BLOW
Protects the ACCESSORY and SAFETY DEVICE power supply.
FAST-BLOW
Protects the control unit at the 24 VAC power supply input.
FAST-BLOW
Protects the flashlight output.
SC24
Publicité
