Publicité
Problems
The gas ring burns unevenly
Burner flame suddenly changes
Ignition of burners takes excessively long Incorrect burner components assembly
The flame goes off after ignition
The colour of the pan support has
changed
The burner fails to ignite after pressing
the knob (the spark-plug emit the spark)
The burner fails to ignite after pressing
the knob (the spark-plug do not emit the
spark)
The ignition generator does not work
The spark-plug emit continuously the
spark
TROUBLESHOOTING TABLE
FOR USERS
Burner crown maybe occluded by dirty
Wrong gas regulation
Incorrect burner components assembly
Early release of knob. Knob is not
Uncorrect pan dimension
Thermocouple problems
Normal situation, caused by the high
Lack of gas or dirty on spark-plug
Spark-plug or ignition generator
Incorrect ignition generator assembly
Incorrect micro-switch assembly or
Causes
pushed in firmly
temperature
problems
Lack of electricity
or break
Humidity
break
Solutions
Clean the burner crown with metal
cleaning agent
Call the assistance
Assembly the burner components
correctly
Assembly the burner components
correctly
Keep the knob pressed longer. Before
releasing the knob, give it one final
solid push
If the flame goes out with a pan larger
than those indicated in the booklet, the
user must use the appropriate
"paellero" grid
Move the thermocouple
Call the assistance
Clean the pan support with metal
cleaning agents
Clean the spark-plug like described in
the cleaning chapter on instruction
manual
Call the assistance
Check that the plug is inserted. Verify
that the counter is turned on.
Call the assistance
Remove the power for 24 hours and
allow the top to dry; verify that all the
bushings are mounted correctly
Call the assistance
35
Publicité
