Thermador An American Icon DWHD43C Guide D'entretien Et D'utilisation page 12

Operating the Dishwasher
Selecting the Proper Wash Cycle
Items with baked-on or hard, dried-on soiling will
require either Heavy Wash or possibly soaking
and hand-scouring.
The Normal Wash cycle will thoroughly clean
large loads having loosely attached normal
soiling. This is the correct cycle for most soil
loads.
The Rinse cycle will allow you to keep a small
load in your dishwasher until you have enough
items for a full load.
To avoid damage to delicate or heirloom
items do not wash them in your dishwasher.
For delicate or heirloom dishware and silverware,
or other special items, select Light Wash after
referring to the Materials section of this manual.
Hand-washing may be the best treatment of such
items.
More information on dishwasher cycles is in the
Wash Cycle Information section of this manual.
Starting the Dishwasher
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
Press the button for the desired wash cycle.
Shut the dishwasher door.
The dishwasher will start automatically and
continue operating until the end of the selected
cycle.
Once you start the dishwasher, leave the
dishwasher door shut until it finishes the cycle.
10
Interrupting a Cycle
NOTE : Should you need to interrupt a cycle (to
add or remove an item, to add detergent, etc.), it
is best to do so within the first 30 minutes of the
cycle.
Open the dishwasher door far enough to expose
the control buttons.
Press the On/Off button.
WARNING
You could be seriously scalded if you open
the dishwasher door quickly during a wash
or rinse cycle. Do not fully open the
dishwasher door for at least 10 seconds or
until water noises stop.
Wait at least ten seconds or until water noises
stop before opening the dishwasher door.
To resume the cycle, press the On/Off button and
shut the dishwasher door.
Canceling or Changing a Cycle
Open the dishwasher door far enough to expose
the control buttons.
To cancel or change a cycle, press and hold for
three seconds the two buttons labeled "Cancel
Drain" as shown in Figure 16.
Figure 16
Cancel Drain
Wait approximately one minute, then press the
On/Off button.
You may now begin a new cycle.