Panasonic EYFNH1XC Instructions D'utilisation page 88

2.3 USING A CONTROLLER TOGETHER
HOW TO PAIR
This tool can communicate the tightening result to the applicable Controller of C.E.
Electronics, Inc.
To establish communication, you need to pair this tool with the Controller (initial operation
for connection).
• You can pair it with the Controller C.E. Electronics, Inc. by performing the following
procedure. (For how to operate the Controller, read the Operating Instructions of C.E.
Electronics, Inc.)
1 Put the Controller of C.E. Electronics, Inc. into the pairing
standby state.
2 Remove the battery pack of the tool once, and attach it again.
3 Pull in the trigger switch for 2 seconds.
If you perform another operation before pulling in the trigger switch, redo the
procedure from
4 The tool indicates that wireless pairing is complete.
5 Check that the tool has been registered, from the display on the
Controller of C.E. Electronics, Inc.
At the time of pairing, you can transmit and register the parameter file registered in the
tool to the applicable Controller of C.E. Electronics, Inc. by wireless.
(For details on how to register it to the Controller, read the Operating Instructions of
C.E. Electronics, Inc.)
EN
2 .
- 88 -
Refer to 2.1.4