Publicité
Les langues disponibles
Les langues disponibles
4.3 ERROR CODES
4.3.1 ERROR CODES ON CONTROL PANEL
If the tool or the battery pack is abnormal, an error code blinks on the control panel.
Before requesting repair, take the following action.
Send it for repair if there is no improvement even after the following action.
Display
Abnormality in the tool's internal
memory or the communication line,
wireless communication, etc.
The battery pack is hot.
The motor of the tool is hot.
Abnormality in the connectors
between the tool and the battery
pack
Overload, failure in the motor, etc.
Error in USB communication with
the Tool Manager software
Break in the USB cable, external
noise
Abnormality, failure, etc. in the
tool's circuit
Error in wireless communication
with the controller
In [Wireless Communication Mode],
use out of the range of wireless
communication with the controller
① Abnormality, failure, etc. in the
torque sensor
② Excessive work time (Excessive
measurement data)
③ Judged NOK
The button battery inside the tool
has run out.
(In [Stand Alone Mode] only)
Excessive batch workload in
[Wireless Communication Mode]
(Excess of the capacity of memory
temporarily storing communication
data)
CAUTION
• Overload protection (E5) may function if you tighten or loosen the bolt that has been
tightened up.
EN
Possible cause
Remove and attach the battery pack once, and then
restart the tool.
If the error persists, initialize the tool's internal
memory. (With "E1" displayed, press and hold the
LED button for about 10 seconds.)
Interrupt work, and replace the battery pack, or wait
for the battery pack temperature to fall before use.
Interrupt work, and wait for the motor temperature to
fall before use.
Check whether there is any foreign body or wear in
the connectors.
Or replace the battery pack.
Check whether the job suits the capacity of the tool.
Check the USB cable for connection.
Replace the USB cable.
Change the workplace.
Restart the tool and the controller.
Check for communication, with another normal tool.
If the error persists, contact the manufacturer of the
controller.
Move into the wireless communication range.
Check whether power to the controller is on.
①
: Pull the trigger switch and restart the tool.
②③ : Work again in [Stand Alone Mode], and check
the error description from the history log.
Reconsider the configured parameters.
Reconsider the workload in a batch.
Select a setting other than [After Batch Complete]
for Set [Graph Sending/Storing Timing].
- 101 -
Action
―
―
Publicité
