Vito Agro VIAB43 Mode D'emploi page 34

Keep all nuts and screws well tightened in order to ensure
a safe operation.
If any components or safety devices are removed for
maintenance works,
immediately.
Never store the tool with petrol in the tank inside a building.
Petrol vapours may come into contact with flames or sparks
and ignite.
Store the earth auger in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment. Avoid places
with high humidity to avoid the appearance of corrosion
and rust.
Clean the equipment thoroughly before storage, especially
in winter. Keep the device in a good operating mode.
Make sure the device is protected against misuse (for
example, by children).
Your earth auger should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer.
1. Fit the drill bit (D) into the output shaft (A);
2. Secure it using the shear pin and split pin (B, C).
When using the earth auger, you should take into
consideration some precautions and procedures of use in
order to avoid accidents, damage and increase the
performance of the equipment:
▪ Ensure that you start your earth auger at a distance of
more than 3m from the fueling site;
they must be repositioned
▪ Always hold the earth auger with both hands;
▪ Do not attach the earth auger to fixed brackets;
▪ When you earth auger, engine is running at idle speed
the drill bit is not rotating. Otherwise, contact technical
assistance to carry out an inspection and solve the
problem;
▪ If you hear an unusual noise or the appliance vibrates
abnormally, stop working and identify the cause.
1. Put the "ON/OFF" switch (G) to "START" position;
2. Press the safety lever (J) and throttle lever (K). Lock the
throttle by pressing the throttle trigger lockout (H);
3. Press the safety lever (J) and throttle lever (K);
4. Set the choke lever (F) to the "CLOSE" position;
5. Press the fuel primer bulb (E) a few times until the is filled
with fuel;
6. Pull the starter handle until the engine starts;
7. Set the choke lever back to the "OPEN" position.
When the starter handle returns to the original
position, the hand and arm can be moved quickly
towards the combustion engine.
As soon as the engine starts, press the throttle to
release the throttle trigger lockout and let the engine
warm up at idle speed for a few seconds before using it.