Publicité
Les langues disponibles
Les langues disponibles
If petrol overflows, immediately clean any spilled fuel. The
combustion engine should only be switched on after the
surface dirty with petrol is cleaned. Any ignition attempt
shall be avoided until the petrol vapors have volatilized (dry
with cloth).
If the petrol has come into contact with clothing, it must be
changed.
Carry the auger only when the engine is off. Before moving
it, stop the engine and wait for the drilling accessories to
stop completely.
Always transport the equipment when the engine is cold
and without fuel. This prevents fuel spillage during
transport.
Always fasten the equipment when transporting it and
install the drill guard.
Make sure that the equipment is only used by people who
are familiar with the instruction manual.
Before starting the auger, check the fuel leak
tightness system, particularly visible parts such as
tank, tank cap, gaskets and carburetor primer bulb. In the
event of leakage or damage, do not start the combustion
engine. Have the auger repaired by an official dealer.
Pay attention to the area where the device will be used and
check for obstacles (rocks, tree stumps, roots, trenches,
etc.), objects (coiled wires, metal parts) or loose stones. Not
being possible to remove these objects or obstacles, mark
them so that they do not come into contact with the drilling
accessories when using the machine.
Before start-up:
▪ Carry out an inspection to ensure that the unit is properly
assembled and that safety issues and performance are
ensured;
▪ Check if the spark plug cap is connected to the spark
plug;
▪ Check if the safety devices are in good conditions and
working properly. Never use the equipment if the safety
devices are missing, damaged or worn out;
▪ Check that the fastening accessories are in good
condition and properly assembled;
▪ Replace damaged parts, as all other worn and damaged
ones;
▪ After assembling the accessories and before using the
device, you must run a test in maximum speed at no load
for a certain time. Check for misalignments in the
moving parts or any other condition that may affect the
operation of the auger. Check that all moving parts
rotate smoothly and without unusual noises;
▪ Perform all adjustments and work necessary. If you have
any questions or difficulties, contact your VITO official
dealer;
▪ Observe the local regulations on the hours when it is
allowed to use tools with a combustion engine and the
permitted noise level.
Keep third parties away from the auger's area of
operation, at least 15m away. Never work while
animals or people, especially children, are in the danger
zone. During work, dirt and stones can be projected at high
speed which can hurt you.
Keep the safety distance from objects (vehicles and
glasses) to avoid property damage.
When working two or more people simultaneously in the
same area, safety distances must be maintained to prevent
accidents and injuries.
Work only in daylight or with good artificial lighting. Do not
use the appliance at night or when it is not possible to have
a clear view of the work area.
Never use the auger with adverse metrological conditions
such as dense fog, rain or strong wind, storms or lightning.
Publicité
