Bodum BISTRO Mode D'emploi page 10

HOW TO USE YOUR HAND MIXER
INSERTING THE ACCESSORIES
– Before inserting the accessories, check that the speed
control (1) is set to position «0» and that the appliance is
disconnected from the mains.
– Insert the selected accessory into the coupling assembly
(8) while rotating it slightly until it engages.
– When inserting the dough hooks (4a, 4b), check that they
are correctly positioned in the coupling assembly (8): the
left dough hook (4a) will only fit in the left–hand aper-
ture (which has a visible step in it). The right dough hook
(4b) will only fit in the right–hand aperture (which has no step
in it).
– The two stirring wands (3) and the whisk (5) fit either
aperture of the coupling assembly (8).
RELEASING THE CORD
– Using one hand to hold the mixer by its handle (11), use
the other hand to pull the cord and mains plug from the
cord compartment (6). Take care not to damage the cord
as you do so.
CONNECTING TO THE ELECTRICAL SUPPLY
– Accessories must always be fitted to the hand mixer
before it is connected to the mains.
– Before connecting the hand mixer to the mains, check
that the speed control (1) is set to position «0».
USING THE MIXER
IMPORTANT: to prevent overheating of the motor, switch
off the mixer after four minutes continuous operation and
wait two minutes before continuing.
– Place the ingredients in a bowl. Ensure that the accesso-
ries do not touch the base or sides of bowls made of glass
or porcelain.
– Immerse the accessories in the mixture and select the
appropriate speed setting (1). See the SPEED SETTINGS
section.
– To avoid splashing, keep the accessories immersed in the
mixture while mixing.
– When you have finished mixing, set the speed control (1)
to «0» and disconnect the mixer from the mains.
– When you have finished using the mixer, place it on the
rest (9) with its four non–slip silicon feet.
REMOVING THE ACCESSORIES
– Before removing the accessories, set the speed control (1)
to «0» and disconnect the mixer from the mains.
– Press the accessory release button (2) to release the acces-
sories. Hold the accessories by the shaft when doing so.
– Note: to safeguard your safety, the accessories can be
released only if the speed control (1) is set to «0».
8