EINHELL 42.599.00 Mode D'emploi page 9

Anleitung_BT_DY_720_E_SPK1:_
5.1 Setting the screwing depth (Figure 2)
Using the depth setting ring (2) with latching settings
you can pre-select the depth to which the screw is
screwed into the workpiece.
PLUS direction: larger screwing depth
MINUS direction: smaller screwing depth
The best way to determine the re-quired setting is
with a test screw.
Press the tip of the screw firmly against the material
in question until the screwing depth stop (1) comes
up against the workpiece and the coupling
disengages.
5.2 Changing the tool insert
To change the tool insert, rotate the screwing depth
stop (1) with the depth setting ring (2) as far as the
maximum screwing depth and pull off the tool insert
to the front (use pincers if necessary).
5.3 Screwdriving work
It is advisable to use self-centering screws (e.g. Torx,
cross recessed head) as these will enable you to
work safely and reliably. Always make sure that the
tool insert used is of the same size and shape as the
screw.
6. Operation
6.1 ON/OFF switch (4)
To switch on:
Press the switch (4)
Continuous operation:
Secure the switch (4) with the locking button (5)
To switch off:
Press in the switch (4) briefly
6.2 Adjusting the speed
You can select the speed by pressing the switch (4)
to a greater or lesser extent.
You can pre-select the speed by turning the knurled
screw in the switch (4).
6.3 Changeover switch (6)
Using the slide switch above the ON/OFF switch you
can select the direction of rotation of the screwdriver.
12.02.2008 13:12 Uhr Seite 9
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
9