Publicité
Les langues disponibles
Les langues disponibles
The film in the upper section is webbed first:
Remove the image guide.
1.
Feed the film underneath (B) the splitter bar (between splitter bar and upper roller)
2.
•
Pressure sensitive film without a release liner must be fed over the splitter bar (A).
Pull the film forward until it almost reaches the in-feed table and apply it to the upper roller.
3.
If the film has a release liner (B):
•
Peel off the release liner,
•
Pull it up and stick it from below onto the cylinder on the wind-up shaft.
Now web the lower section:
Figure 19: Webbing lower section.
Lift the in-feed table and put it in the upper position (A).
1.
Unwind the film from the lower unwind roll.
2.
•
Feed a pressure sensitive film without release liner underneath the splitter bar (A),
•
Feed all other films over the splitter bar (B).
Pull the film forward until the end reaches above the nip and stick it to the film from the upper
3.
section.
If the film has a release liner (B):
•
Peel off the release liner and pull it over the wind-up shaft,
•
Stick it from above onto the cylinder on the wind-up shaft.
Lower the in-feed table.
4.
Push the films with a leader panel (C) into the nip using slow mode (B).
5.
Note: Use a leader panel of the same material, thickness and width as the panels to
process. Use a release board when processing thin images.
Operating
25
Publicité
