Publicité
Les langues disponibles
Les langues disponibles
5.4.1 Upper section only
Figure 17: Webbing upper section.
Remove the image guide.
1.
Unwind the film from the upper or top unwind roll.
2.
•
Feed a pressure sensitive film without release liner over the splitter bar (A).
•
Feed all other films underneath the splitter bar (B).
Pull the film forward until approximately 10 cm (4 in.) is on the in-feed table.
3.
If the film has a release liner:
•
Peel off the release liner.
•
Pull the release liner up and stick it to the scrap core on the wind-up shaft.
Stick the leader panel to the film and feed the panel into the nip using slow mode.
4.
Note: Use a release board when processing thin images without using carrier boards.
5.4.2 Upper and lower section
A release board or a leader panel of the same thickness as the panels to process is needed.
Figure 18: Upper and lower section webbed.
Publicité
