Publicité
Les langues disponibles
Les langues disponibles
d) Initial operation
On the side of the loudspeaker (3) is a slider, which serves to turn the signal off or set it at two
volume stages (Lo = normal volume, Hi = loud).
With correct installation, the parking system turns on automatically when putting the gear to
reverse.
With the acoustic system, an acknowledgement beep sounds for approx. 1 second.
Test the system prior to first use to familiarize yourself with the buzzers and signals.
Ask a second person to simulate the „obstacle" behind your car.
To do so, switch on the ignition (on-board voltage supply) and then put the car into reverse.
Ask the second person to slowly advance to the car from approx. 1.4 m distance.
The distance to an obstacle is also signalled with increasing intensity of the signal (large dis-
tance = slow beep, smaller distance = faster beep until it sounds permanently). The acoustic
signal is identical with both parking aids. The following ranges must be observed:
Safe range from 140 - 100 cm.
Warning range from 90 to 50 cm.
Dangerous range from 40 - 0 cm (<30 cm permanent beep).
In certain situations, the ultrasound measuring principle is not reliable.
This may be the case on slight slopes, rounded or soft objects, which absorb the ultrasound
waves.
e) Reverse sensor head products
Observe the following hints when painting over reverse sensor heads.
Painting of Reverse Sensor Heads
1
Caution! Please note that extreme care should be taken if you decide to paint the
reverse sensor heads to match the colour of your vehicle.
•
Some cleaning agents, solvents and certain paints may damage the heads and cause the
reverse sensors to malfunction. Also,placing too much paint on the reverse sensor heads
may affect functionality.
•
Failure to adhere to the following recommendations may affect the function of your system
or stop it functioning altogether.
•
The manufacturer and supplier will not be held responsible for any correction, replacement
or damage caused.
25
Publicité
