Replacement Of The Upper And Lower Bushes - V.ORLANDI E 50 Instructions De Montage, D'utilisation Et D'entretien

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

5.6 REPLACEMENT OF THE UPPER AND LOWER BUSHES

ATTENTION: Make sure that the drawbar coupling is closed, ie. the
coupling pin (14) is down.
Remove the coupling from the truck (see chapter 5.1 REPLACEMENT OF THE
1)
RUBBER BUFFERS AND THE INNER BUSH, page 21/32);
Remove the mechanism unit (see chapter 5.2 REPLACEMENT OF
2)
THE MECHANISM UNIT AND THE COUPLING PIN, page 22/32);
3)
Remove the coupling jaw (see chapter 5.4 REPLACEMENT OF THE COUPLING
JAW, page 24/32);
Remove the bushes (6, 26a) and replace them (see chapter 7 DISPOSAL on
4)
page 30/32), (see also the removal of the wear pad 25M-25P chapter 5.5
REPLACEMENT OF THE WEAR PAD OF THE LOWER BUSH, page 25/32).
When fitting the lower bush (26a) take care to position the peg "P" into its
seat "S";
5) Refit all the parts as described in chapters 5.1 REPLACEMENT OF THE RUBBER
BUFFERS AND THE INNER BUSH, page 21/32, 5.2 REPLACEMENT OF THE
MECHANISM UNIT AND THE COUPLING PIN, page 22/32, 5.4 REPLACEMENT OF
THE COUPLING JAW, page 24/32.
9
DRAWBAR COUPLING E 50
6
26a
SEAT "S"
PAG.
26/32
CHAP . 5
REV. F
PEG "P"