Publicité
Les langues disponibles
Les langues disponibles
How to re-install the door
1. Firmly grasp both sides of the door at the top.
2. With the door at the same angle as the removal position, slide the indentations
of the hinge arms into the bottom edges of the hinge slots. The notches in each
hinge arm must be fully inserted into the bottoms of each slot.
Bottom edge of slot
Hinge arm
Indentation
3. Open the door fully. If the door will not open fully, the indentations are not
inserted correctly in the bottom edges of each slot.
4. Push the hinge locks up against the front frame of the oven cavity into the
locked position.
5. Close the oven door.
NX58R9311SS_AA_DG68-00905B-00_EN+MES+CFR.indb 35
Hinge lock
Locked position
Unlocked position
How to remove and re-install the Storage drawer
Storage drawer
1. Pull out the drawer and remove any
2. While supporting the drawer, pull it out
3. Clean the drawer with warm, soapy
4. Place the top of both drawer sides in
5. Replace any stored content, and then
stored content.
until the top of the drawer sides come
out of the two nylon drawer guides.
Then, lift to remove the drawer.
water. Rinse and dry thoroughly.
the openings on the two nylon drawer
guides and push in enough to support
the drawer.
push in the drawer while slightly lifting
the front to close it.
English 35
2019-05-30
6:11:15
Publicité
