Motec MD3071A Notice De Montage Et D'utilisation page 57

3 Controls and display elements
The MD3071A provides 3 switchable video inputs (of which 2 as camera inter-
faces) 6 control line inputs, 1 control line output and settings and permissions
which can be configured from the screens. This provides a range of combination
options for adapting to the application with respect to operation and to statutory
requirements.
Note:
These instructions describe the full functionality. If the monitor has been installed
for a specific application from the factory or upgraded by a service partner, all
the functions may not be available. In accordance with the permissions set and
- or the mode selected functions which are not available are greyed out in the
on-screen menu.
3.1 Before use
Before using or adjusting the monitor, remove the
protective film on the display, if there is one.
There is a red tab on the top right hand corner.
Pull the film by the tab from the top right towards the
bottom left.
EN
57