Wolf PRO WALL Guide D'installation page 6

I NSTAL L AT IO N
Electrical Connections
WARNING
Before making electrical connections, verify the power
is turned off at the service panel.
IMPORTANT NOTE: Refer to installation instructions pro-
vided with the blower assembly.
I NTERN A L B L O WE R
Connect black to black and white to white with the
1
provided connectors, and connect the green/bare wire
to the ground screw.
Verify all wires are secure and not pinched, and reinstall
2
the box.
Plug the blower power cord into the receptacle inside
3
the hood. Refer to the illustration below.
Turn on the power to the hood and verify light and
4
blower operation.
RECEPTACLE
ELECTRICAL
BOX
Electrical connections
6 | English
IN- LIN E / R EMO TE BLO WE R
Connect the home supply. Connect black to black and
1
white to white with the provided connectors, and con-
nect the green/bare wire to the ground screw.
Connect the blower supply to the power cord provided
2
with the blower. Connect black to black, white to white,
and the green/bare wire to the ground screw.
Verify all wires are secure and not pinched, and reinstall
3
the box.
Plug the blower power cord into the receptacle inside
4
the hood. Refer to the illustration below.
Turn on the power to the hood and verify light and
5
blower operation.
RECEPTACLE
ELECTRICAL
BOX
Electrical connections
Complete the Installation
G RE A SE C U P, S PA C E RS, AN D FILTER S
Install the grease cup(s), then install the spacers and filters.
Refer to the illustrations below.
SPACER
FLANGE
GREASE
CUP
Grease cup Spacer
Filters
L IGH T B UL B S
A suction-cup-style light bulb changer is provided with
the hood. To install, use the changer to push the bulb into
the receptacle and rotate counterclockwise one-quarter
turn. Refer to the illustration below.
For 686 mm deep wall hoods, install the heat lamp bulbs
(not included). Use E27, R125 (220–240V, 250W maximum)
bulbs.
W OL F L OGO
To attach the Wolf logo, clean the mounting area with
rubbing alcohol. Remove the paper backing, position the
logo parallel with the bottom of the hood, and press into
place.
LIGHT BULB
CHANGER
Light bulb