Simons Voss Technologies SMARTCD2.G2 Guide Abrégé page 26

8. Signalling
8. Signalling
LED 1 lights up green.
LED 1 flashes green.
The first LED lights up when connected via USB on the PC/laptop or
without USB connection only after the SmartCD2.G2 has been switched
on by pressing the button. The device can be switched off again to save
power by re-pressing the button.
LED 2 lights up yellow.
LED 2 is off.
The second LED only lights up when:


LED 3 flashes green quickly.
LED 3 flashes green slowly.
The third LED only signals only when wireless communication is active
(e.g. programming, readout) between programming device and a
corresponding locking device.
26 / 100
The programming device is connected to a suitable USB port for
charging and
At least one of the batteries must be charged.
Programming device
SmartCD2.G2
Programming device ready
for operation.
Programming unit in
standby mode.
Batteries are being charged.
Batteries are fully charged.
Communication with a
SimonsVoss locking device.
No connection.
EN