Simons Voss Technologies SMARTCD2.G2 Guide Abrégé page 23

Programming device
SmartCD2.G2
All digital locking devices and all active transponder media in
SimonsVoss System 3060 can be programmed using a SmartCD2.G2 in
conjunction with a PC/laptop.
NOTE
SmartCD2.G2 coupling on the Smartphone
It is not possible to use Bluetooth to communicate between
SmartCD.G2 and a PC or laptop.

USB and Bluetooth cannot be used simultaneously
You must ensure that the Bluetooth connection is not active before connecting
SmartCD2.G2 to the USB port. The Bluetooth function switches off automatically after
15 minutes. It can also be switched off manually by pressing a button on the program-
ming device. If this not the case, communication cannot be established via the USB port.
Transponders can only be programmed if the SmartCD2.G2 is
connected directly (via USB cable) to a PC/tablet/laptop and the LSM
software is installed.
6. Getting started
1. Install the LSM software.
EN
If you are using the SmartCD2.G2 with a smartphone via Bluetooth,
then unplug the connection cable from the SmartCD2.G2 to the PC/
laptop again.
9 Required drivers are installed automatically.
6. Getting started
23 / 100