Simons Voss Technologies SMARTCD2.G2 Guide Abrégé page 24

7. Programme
2. Connect the programming device to a USB port (see
9
7. Programme
During programming, there should a minimum gap of around 10 cm
between SmartCD and the locking device; for SmartRelay it should be
around 30 cm and 70 cm for the block lock.
7.1 Programming with a PC or laptop
ü
ü
1. Click the button Programming in the LSM software.
2. Follow the further instructions.
The current version of the LSM software must be installed on the PC/
laptop.
24 / 100
}
[ 22] ).
The programming device is ready for use.
Current version of the LSM software installed.
Programming device connected via USB (no Bluetooth available).
The window "Programming" opens.
9
Programming device
SmartCD2.G2
Connecting
EN