Quick Setup - Alto Professional STAGEDRIVE+ Guide D'utilisation Simplifié

QUICKSTART GUIDE (ENGLISH)
BOX CONTENTS
STAGEDRIVE+
Power cable
Software CD
Quickstart Guide
Safety & Warranty Information Booklet

QUICK SETUP

Make sure all items listed in the BOX CONTENTS section are included in the box.
1.
READ SAFETY & WARRANTY INFORMATION BOOKLET BEFORE USING THE PRODUCT.
2.
Study the connection diagram in this guide.
3.
Place all devices in an appropriate position for operation.
4.
Make sure all devices are turned off and all faders and gain knobs are set to "zero."
5.
Connect all sound sources' outputs to amplifier inputs as indicated in the diagram.
6.
Connect the amplifier outputs to speakers.
7.
Plug all devices into an appropriate power source.
8.
Switch everything on in the following order:
9.
•
Sound sources (i.e. microphones, turntables, CD players, etc.)
•
Mixer
•
Amplifier
•
Speakers
When turning powering down, turn everything off in the following order:
10.
•
Speakers
•
Amplifier
•
Mixer
•
Sound sources
FRONT PANEL DIAGRAM
1
1. MODE BUTTON- Selecting one of four modes: PRESET, DELAY, EDIT and UTILITY.
2. DISPLAY- Shows the pages of the various menus and their parameters.
3. DIAL KNOB- Edits the value of the selected parameter.
4. PREV/NEXT BUTTON- Accesses menu pages and/or parameters.
5. NAVIGATION CURSOR KEYS- Selects various parameters.
6. MEMORY CARD SLOT- MMC card slot to store PRESETS.
7. ENTER KEY- Confirms editing of parameters.
8. ESC KEY- Exits the selected editing page or cancels an editing operation.
9. INPUT LEVEL LEDs- Shows the level of input A/B.
10. MUTE SWITCHES- Mutes the signal from any of the six respective outputs.
11. OUTPUT LEVEL LEDS- Shows the output level.
Note: The LIMITER will change the way in which the output level is displayed on the corresponding LED. The
level shown on the meter is no longer the "absolute" output level, but the level of the signal at -24dB, -12dB,
-6dB compared to the limiter threshold (indicated by the orange LIMIT LED).
2
3
11
4
7
5
8
6
9
10