Software Setup - Alto Professional STAGEDRIVE+ Guide D'utilisation Simplifié

• Accept and execute PRESET Change commands.
SOFTWARE DRIVER SETUP
Insert the included software CD into your computer's disc drive.
1.
Navigate to the MaxiDrive3.4 DPA software/USB Driver folder to locate and install the PL-2303 Driver
2.
Installer.exe associated with your version of Windows.
Once the driver is installed, power on the STAGEDRIVE+ and connect the USB cable from the
3.
STAGEDRIVE +'s USB port to your PC's USB port.
Right click on MY COMPUTER then click PROPERTIES.
4.
Click the HARDWARE tab, then select DEVICE MANAGER.
5.
Double click PORTS (COM & LPT), and look for PROLIFIC USB-to-SERIAL Com Port
6.
Double click PROLIFIC USB-to-SERIAL Com Port, then click PORT SETTINGS, then click
7.
ADVANCED.
Change the COM PORT NUMBER to COM1 (or any other com port not in use) and click Ok.
8.

SOFTWARE SETUP

The software editor can be setup as seen below:
1. Once the software driver has been installed (with the STAGEDRIVE+ powered on and connected to the
computer via USB), launch the software editor program.
2. Select New
3. Select your interface from the list.
18