Parkside PHSSA 20-Li A1 Traduction Des Instructions D'origine page 7

- When you inspect the device,
clean it or remove blockages;
- When you perform clean-
ing or maintenance work, or
swap accessories;
- After contact with foreign ob-
jects or if abnormal vibration
occurs.
• Do not submerge the device in
water and do not operate it in a
damp environment.
• Do not submerge the device in
water!
• Do not touch the device with
wet or damp hands!
This is how to avoid damage to the
equipment and possible personal
injuries resulting from this:
• Make sure before use that the
device is properly assembled
and that the filters are in the cor-
rect position.
• Do not operate the device with-
out filters. The device could be-
come damaged.
• Only use original spare parts and
accessories (see "Spare parts/
accessories") which are supplied
and recommended by our service
centre. Using externally pro-
duced parts results in the imme-
diate loss of the warranty claim.
• Only have repairs performed by
customer service centres author-
ized by us.
• Comply with the device's cleaning
and maintenance instructions.
• Store the device in a dry place
and out of reach of children.
Observe the safety informa-
tion and notes on charging
and proper use as shown in
the instruction manual for
your battery and charger
from the Parkside X 20 V
Team series. A detailed de-
scription of the charging pro-
cess and further information
can be found in the separate
instruction manual.
Initial start-up
Before each use, ensure the filter (3) and
filter holder (2) are sitting correctly in the
collection container (1).
Also inspect the device visually for damage.
Do not operate the device if dam-
aged or incorrectly assembled!
Replace damaged parts and dirty
filters. See "Spare parts/accesso-
ries".
Ensure that the battery is not insert-
ed! (See section "Inserting/removing
the rechargeable battery")
1. Remove the collection container (1) by
pressing the release button (4) and de-
taching the collection container (1).
2. Check that the filter holder (2) is sitting
securely against the mechanical stop
in the collection container (1) by lightly
pressing the filter holder (2). Due to its
shape, the filter holder (2) can only be
inserted into the collection container (1)
in one position.
3. Check whether the filter (3) is sitting
securely in the filter holder (2). Lightly
press the filter into the filter holder (2).
4. Re-attach the collection container (1)
onto the device. Place it on the under-
side of the device and allow it to latch
into the interlock release on the top
side of the device.
GB
7