Parkside PHSSA 20-Li A1 Traduction Des Instructions D'origine page 9

Switching on:
Push the on/off switch (5) forwards.
Switching off:
Pull the on/off switch (5) backwards.
Emptying the collection
container
Empty the collection container (1) after
every use.
Empty the collection container if suction
performance is decreasing.
If the collection container is full of dust or
the filter becomes wet from wet vacuum-
ing, the cordless hand-held vacuum clean-
er may become damaged!
Emptying the collection con-
tainer after wet vacuuming:
Hold the collection container
with the wet nozzle pointing
downwards when removing
it to prevent liquid getting
into the device!
1. Remove the collection container (1)
carefully by pressing the release button
(4) and removing the collection con-
tainer (1).
2. Carefully remove the filter (3) and filter
holder (2) from the collection container
(1).
3. Empty the collection container (1).
4. Clean the collection container (1) with
a damp cloth if required. If required,
clean the filter (3) as indicated in the
"Cleaning" section.
5. Place the filter holder (2) and filter (3)
back into the collection container (1).
Due to its shape, the filter holder (2)
can only be inserted into the collection
container (1) in one position.
6. Re-attach the collection container (1)
onto the device. Place it on the under-
side of the device and allow it to latch
into the interlock release on the top
side of the device.
Cleaning
Always remove the recharge-
able battery before carrying
out work on the device.
Risk of injury!
Never spray down the device
with water or place it in wa-
ter! Do not use any abrasive
cleaning agents or solvents.
The device could become
damaged.
• Clean the housing with a dry cloth or
paint brush.
• Tap the filter (3) and clean it with a
brush or compressed air.
If the filter is contaminated and cannot
be cleaned, replace it!
See "Spare parts/Accessories".
• Empty the collection container (1) after
every use.
Clean the collection container (1) with
a damp cloth.
• Always keep the ventilation slit on the
device housing unobstructed otherwise
the device will overheat.
Maintenance
Replacing the filter
If contaminated, replace the filter with a
new one.
New filters can be acquired from the
online shop. See "Replacement parts/Ac-
cessories".
GB
9