Télécharger Imprimer la page

Pentair Flotec SUB 3S Manuel D'utilisation Et D'entretien page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
CHAPTER 3
INSTALLATION (SEE FIG. 1)
DANGER - ELECTRIC SHOCK RISK
When installing, please ensure electropump is disconnected from electrical supply. Pumps in this
series are not suitable for use in a swimming pool and the relevant cleaning and servicing operations.
DANGER
To prevent possible injuries to people, avoid inserting hands into the mouth of the pump if this is connected
to the mains.
DANGER
This appliance can be used by children aged 8 years or over and by persons with limited physical, sensory or
intellectual capabilities, or with limited experience and knowledge, provided that they are supervised or have
been instructed in the safe use of the appliance and are aware of the dangers involved. Children must not be
allowed to play with the appliance. Cleaning and user maintenance must not be carried out by children unless
they are supervised
Use the handle provided to transport or lift the pump.
To use the pump in permanent installations with rigid pipes, to install a check valve to avoid the fluid being re-cir-
culated once the pump is stopped. The installation of a quick closing fitting in a convenient position facilitates
cleaning and maintenance operations.
The dimensions of the collection container should reduce to the minimum the number of starts per hour (see LIMI-
TATIONS - Technical data).
To use the pump for temporary applications, install a flexible pipe and connect it to the pump using a pipe holder. To
immerse the pump, use a rope and fix it to the handle.
SUB 3S pumps have a pre-set floating switch. To change the setting, it is necessary to increase or reduce the length
of the floating switch cable by sliding it in the slot on the handle (See Fig. 1).
Install the pump at least 50 cm from the bottom of the well to avoid taking in sand, mud, etc
WARNING
Verify that the floating switch stops the pump as soon as the minimum level is reached.
WARNING
Make sure that the floating switch is free to move.
WARNING
The pump is to be installed on a stable surface. Do not rest it on stones or sand without levelling.
WARNING
Use pump in clear water free from the presence of sand or other particles which may cause the pump to
block.
WARNING
Do not position the pump on the bottom in order to avoid suctioning sand, mud and other particles which
could damage it.
WARNING
Pollution of the liquid could occur due to the leakage of lubricants
USE AND MAINTENANCE MANUAL
EN
9

Publicité

loading