Urmet 9854/58 Manuel Pour L'utilisateur page 16

will need 50s to start up; during this
time, the LED will remain off.
2. PROGR/RESET key: by pressing the button
for a time
• comprised between 2s and 4s, the device
will restart in the configuration mode
(maintaining any parameters that had already
been configured);
• shorter than 2s or longer than 4s, the
device will be restarted.
After 5 short consecutive presses
(at time intervals shorter than 1s)
the device will restore its factory
parameters and signal the event
with a flashing red/orange/green
LED light, to then switch to the
configuration mode.
After 3 short consecutive presses
(at time intervals shorter than 1s)
the device switches to Upgrade
mode. The green LED will blink
continuously to indicate the event.
3. LAN connector: Ethernet port for wired
connection to the home network.
4. Jumpers to define the type of power supply
to the device.
Power from external local power
supply (DEFAULT)
DO NOT MOVE
5. +/- 24V terminals: external local power supply
terminals.
6. Terminal board R2, R1, V3, V5, V4
R2: video power positive (+18Vdc).
R1: video power earth.
V3: composite video signal input.
V5: composite video signal (shield) earth.
V4: composite video signal output.
7. Jumper 6-10: for selecting closing/separation
of the audio earth to the door opener earth.
Short-circuited audio earth and
door opener earth (DEFAULT)
Separate audio earth and door
opener earth
16
8. Jumper A-V: for selecting the type of door unit
to which the device is connected.
Door phone
Video door phone (DEFAULT)
9. Jumper 1-1A: for selecting call type.
Door phone with buzzer
Door phone/ video door phone with
electronic call function (DEFAULT)
10. Terminal board RD, CA, 10, 9, 1, 2, 6.
RD: video power input/output (positive).
CA: call input (electronic or to buzzer).
10: door opening earth.
9: door opener control.
1: audio output (door phone speaker).
2: audio input (door phone microphone).
6: audio earth.
Power supply (provided)
1
1. N, L terminals: Input voltage 110/230Vac
2. V-, V+ terminals: Call-Forwarding device
power voltage output
2
V- V- V+ V+
NC NC N L
DS9854-005D