Urmet 9854/58 Manuel Pour L'utilisateur page 13

2. DEVICE INSTALLATION
Installation of the device must be carried out by a
skilled installer.
The product is designed to be powered according
to national system regulations.
The Call Forwarding Device can be used to
forward a voice-video call or a voice-only call to
a smartphone with the Android or iOS operating
system.
This is done by establishing an Internet connection
through an ADSL router/modem or via 3G/4G using
a Cat5 cable or via Wi-Fi.
The device was designed for use in
homes and can be used to configure
only some network parameters. If may
consequently not work on specific
business IP networks.
The Urmet CallMe App must be downloaded to the
user's smartphone, connected to the Internet via a
mobile data or Wi-Fi connection, in order to be able
to receive the call.
In addition to receiving the call, the Urmet CallMe
App also ensures intercommunication with other
smartphones connected to the same account.
Moreover, the Urmet CallMe App is necessary to
be able to configure the device parameters.
The Call Forwarding Device only works
in combination with one or more indoor
stations available in the apartment.
To ensure correct operation of the Urmet CallMe
App, some essential requirements must be
verified:
1) good Wi-Fi signal quality on the device;
2) upload data band ≥ 300 kbps for the Internet
service supplied by your home provider to the
device;
3) check that your smartphone data plan does not
require VoIP data flow locking.
WARNING
Applications that:
— optimise the use of the battery,
— ensure energy saving for your smartphone,
— protect the device
software),
could adversely affect the operation of the
Urmet CallMe application when in the off-screen
(background) mode.
DS9854-005D
INSTALLER MANUAL
(antivirus or similar
The device was tested on the following basic
system types:
• 4+n wire door phone with electronic call or
buzzer;
• Video door phone with coaxial cable and
electronic call.
Operation on different types of systems is not
guaranteed.
The Call Forwarding Device can be installed in one
of the following ways:
2.1. IN A CONTROL PANEL
1. Insert the spacer behind the device in its special
seat, ensuring that it is locked by the lever A.
2. Insert the retainers B of the spacer in the DIN
rail in such a way that the terminal strips of the
device are pointing downwards, then insert the
retainers C.
3. Couple the power supply provided on the DIN
bar on the left of the device.
4. Remove the terminal strip cover.
2
1
1
2
A
C
B
C
B
3
13