Makita DMR057 Manuel D'instructions page 9

● The charger may not supply power to some USB
devices.
● When not using or after charging, remove the USB
cable and close the cover.
● Do not connect this USB socket with your PC USB port,
as it is highly possible that it may cause breakdown of
the units.
LISTENING TO FM RADIO
Tuning into FM stations
To tune into FM radio stations, follow these steps:
1. Turn on the radio using the Power button.
2. Select the FM radio mode by repeatedly pressing the
Mode button.
3. Press and hold the Tuning up or Tuning down button
to automatically tune into an FM station with a higher
or lower frequency respectively. Your radio will stop
scanning when it finds a station of sufficient strength.
The display will show the frequency of the signal which
has been found.
4. Press the Tuning up or Tuning down button to fine-tune
the frequency if needed.
5. Repeat the steps 3 and 4 to tune into other radio stations.
NOTE:
For FM radio mode, if the radio's reception is not good,
it may be necessary to relocate your radio to a position
giving better reception.
Preset memory stations
The FM radio has 9 preset stations.
1. Press the Power button to turn on the radio.
2. Press the Mode button to select the FM radio mode.
Tune to the required radio station as previously
described.
3. Press and hold the Preset up or Preset down button
until "M" flashes on the display.
4. Press the Preset up or Preset down button to select the
desired memory number.
5. Press and hold the Preset up or Preset down button
until "M" stops flashing on the display. The radio station
is stored into the selected memory preset. The display
will appear with the memory number.
6. Repeat this procedure as needed for the remaining
presets. Preset stations which have already
stored may be overwritten by following the above
procedure if required.
Recall memory station
1. Turn on the radio and select the FM radio mode.
2. Momentarily press the Preset up or Preset down button
to tune to your radio to one of the stations stored in the
preset memory.
LISTENING TO MUSIC VIA
BLUETOOTH STREAMING
You need to pair your Bluetooth device with the radio
before you can auto-link to play/stream Bluetooth music
through the radio. Pairing creates a 'bond' so two devices
can recognize each other.
Note:
● To have the better sound quality, we recommend
setting the volume to more than two-thirds level on your
Bluetooth device and then adjust the volume on the
radio as required.
● The radio can memorize up to 8 sets of paired device,
when the memory exceeds this amount, the oldest
pairing history will be over written.
Pairing your Bluetooth device for the
first time
1. Press the Power button to turn on the radio. Press the
Mode button to select Bluetooth mode. The Bluetooth
status icon flashes on the display to show the radio is
discoverable.
2. Activate Bluetooth on your device according to the
device's user manual to link to the radio. Locate the
Bluetooth device list and select the device with the
name of your radio (With some mobiles which are
equipped with earlier versions than BT 2.1 Bluetooth
device, you may need to input the pass code "0000").
3. Once connected, there will be a confirmation tone
sound. The Bluetooth icon will cease flashing. You can
simply select and play any music from your source
device. Volume control can be adjusted from your
source device, or directly from the radio.
4. Use the controls on your Bluetooth-enabled device or
on the radio to play/pause and navigate tracks.
Note:
● If 2 Bluetooth devices, pairing for the first time, both
search for the radio, it will show its availability on both
devices. However, if one device links with this unit first,
then the other Bluetooth device won't find it on the list.
● If your Bluetooth device is temporarily disconnected to
the radio, then you need to manually reconnect your
device again to the radio.
● If the name of your radio shows in your Bluetooth
device list but your device cannot connect with it,
been
please delete the item from your list and pair the device
with the radio again following the steps described
previously.
● The optimal Bluetooth transmission range is
approximately 10meters (33feet) in line of sight to
the radio, but a distance up to 30meters (100feet) is
possible.
● If Bluetooth connection is lost due to exceeding time of
separation, exceeding the optimum distance, obstacles
9 ENGLISH