Adjusting Seat Height - Drive Litec Manuel D'utilisation

EN
Assembly
Attach wheels and unfold
Attach the wheels by pressing the unlock button in the
middle of the hub and insert the wheel into the designated
socket on the base. Please make sure that the wheels are
properly locked before use, by pulling the wheel towards
you away from the wheelchair. (Picture 1+2).
Unfold the wheelchair by pushing the seat until it locks
in place.
Mounting footrests
Mount both footrests as shown in and move them to the
inside until you perceive a clear audible snap. Pull the
lever upwards and move the footrest to the outside, in
order to release/ remove them. (Picture 3+4).
Adjusting length of footrest
Adjusting length (Picture 5):
Open and remove screw on the inside of the footrest with
the allen key and adjust the length to fit your needs. Check
where the threaded hole is and install the locking screw.
Tighten screws!
Adjusting inclination (Picture 6):
Undo the screw on the side of the footrest (plate) with
an allen key and pull it out of the gearing. Then push the
plate back into the gearing after adjusting the inclination
Retighten screws!

Adjusting seat height

The height of the seat can be adjusted in 3 positions.
Remove both wheels by pushing the release button in
order to adjust the height.
Open the nut on the wheel receiver and move it to the
desired drilling. Install the nut with the lock washer and
tighten it. (Picture 7).
Make sure the nut is securely tightened!
Adjusting sitting height (front wheels)
The sitting height in the front can be adjusted in 3 posi-
tions as well as the desired inclination. (Picture 8).
Remove the screw from the axle in order to adjust.
The plugs in the holes are easily replaced.
Adjust the height and tighten the screw.
Make sure the axle is securely tightened!
10
1
3
5
7
8
2
4
6