Mitsubishi Electric City Multi PAC-PH01EHYU-E Manuel D'installation page 17

8
XL-module
Right side
[Fig. 8.1.2.1]
<A>
<A>As with <A> and <B> in [Fig.8.1.0.1], remove the water-proof cap from the unit wiring connector.
<B>Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<C>Connect the panel heater wiring and the unit wiring and run the connected wiring between the fin
guard and the pillar.
<D>As with <E> in [Fig.8.1.0.1], place the cover back and fix the cover with the tie band.
A Unit wiring
B Cover
C Panel heater wiring
D Fin guard
E Pillar
F Tie band
[Fig. 8.1.2.2]
A
D
C
B
<A>Screw down the metal sheet wiring cover and the fin guard
A
A Fin guard
B Cover wiring 1
C Cover wiring 3
<A>
B
C
8.1.2
A
<C>
E
at three points.
D
A
F
<D>
B
E
C
<D>
17