Mitsubishi Electric City Multi PAC-PH01EHYU-E Manuel D'installation page 16

8
[Fig. 8.1.1.5]
Right rear side
A
<C>
C
<B>
D
E
Left rear side
Right rear side
[Fig. 8.1.1.6]
<A>
B
D
16
A
Left rear side
B
D
A
F
B
C
E
A
Rear side
8.1.1
<A>As with <A> and <B> in [Fig.8.1.0.1], remove the
water-proof cap from the unit wiring connector.
<B>Pull up the panel heater wirings so that the wirings
run along the right rear pillar.
<C>Connect the panel heater wiring and the unit wiring
and run the connected wiring between the fin
guard and the pillar.
<D> As with <E> in [Fig.8.1.0.1], place the cover back
and fix the cover with the tie band.
A Unit wiring
B Cover
C Panel heater wiring
D Fin guard
E Pillar
F Tie band
D
A
<D>
<D>
B
<D>
<D>
C
<A>
<A>Screw down the metal sheet wiring cover
and the fin guard at three points.
A Fin guard
B Cover wiring 1
C Cover wiring 2
D Cover wiring 3
B
D
E
Left rear side
A
<C>
C
<B>
D
E