Electrical Wiring - Mitsubishi Electric City Multi PAC-PH01EHYU-E Manuel D'installation

8. Electrical Wiring

8
S-module
[Fig. 8.1.0.1] Left side
C
<A>
A
D
<B>
10
A
A
<D>
E
<C>
F
G
B
B
<A>
<A>Cut the tie band that fixes the cover of the unit wiring and remove the cover.
<B>Remove the water-proof cap from the unit wiring connector (the male end of the
connecter).
<C>Pull up the panel heater wirings so that the wirings run along the left rear pillar.
<D>Connect the panel heater wiring and the unit wiring and run the connected wiring
between the fin guard and the pillar.
<E>Place the cover back and fix the cover with the tie band.
A Unit wiring
B Cover
C Tie band
D Water-proof cap on the unit wiring connector
E Panel heater wiring
F Fin guard
G Pillar
8.1.0
F
A
F
G E
A
C
<E>
B
E