Replacing The Oven Lamp; Discarding & Environment - Hendi 4x GN 2/3 Mode D'emploi

REPLACING THE OVEN LAMP

Disconnect the appliance electrically; remove the
lateral support for cooking vessels by lifting the
support upwards. Wait for the cover and the lamp
to cool and then unscrew the protecting glass cov-
er without using tools so as to avoid breakages.
MAINTENANCE
Our appliance does not require scheduled mainte-
nance but an annual maintenance contract should
nevertheless be drawn up in order to keep the appli-
ance safe and in perfect working order.
For information purposes, maintenance must apply
to:
• gas part – pressure adjustment, checking seal,
correct operation, status of switch-on electrode,
fume discharge, etc.
Electrical data table
Terminal block fitting for 3 x 1.5 mm cable, voltage
230 VAC 50 HZ class 1 Fitting for circuit breaker
Water data table
Water inlet fitting = ¾ inch thread with seal washer
Drainage fitting = stainless steel pipe, 25 mm diameter.
7. DISCARDING & ENVIRONMENT
When decommissioning the appliance, the prod-
uct must not be disposed of with other household
waste. Instead, it is your responsibility to dispose to
your waste equipment by handing it over to a des-
ignated collection point. Failure to follow this rule
may be penalized in accordance with applicable
regulations on waste disposal. The separate col-
lection and recycling of your waste equipment at
the time of disposal will help conserve natural re-
Unscrew the lamp and replace it with another one
having these features:
Voltage: 230/240 V, power: 15 W, attachment: E14
Refi t the glass cover and the lateral cooking vessel
support and connect the power supply.
• electrical part – checking power cable, lamps and
pilot lights, checking electrical resistances, fan and
safety systems, etc.
• hydraulic part – checking seal of water system, jet
of humidifi er, water pressure, etc
• internal cleaning – removal of residue from cook-
ing chamber, including fan blades (after removal
of fan cover), removal of residues from discharge
routes, etc.
connection for cables up to 3 mm2
sources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off
your waste for recycling, please contact your local
waste collection company. The manufacturers and
importers do not take responsibility for recycling,
treatment and ecological disposal, either directly
or through a public system.
EN
9