Power Requirements; Important; Starting Up - Nordcap ABS Série Manuel D'utilisation

Power Requirements

The cabinet is intended for connection to an alternating current. The connection voltage
(V) and frequency (Hz) are shown on the nameplate in the cabinet. The power
connection is made using a three-pin plug to a wall socket. Any requirement for earthing
from the local power supply must be met. The cabinet plug and wall socket should then
give a correct earthing. If you are in doubt, contact your local supplier or authorized electrician.
Warning - This appliance must be earthed
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13 Amp plug. If a B.B.
1363 (13 Amp) fused plug is used, it should be fitted with a 13 Amp fuse or a moulded right-angled
Schuko plug. Note the plate with a hole in it between and above the two pins - this connects to
French and Belgian sockets, which have an earth pin that sticks out. Running in a slot coming from
that plate is a continuation strip from the plate. Other European countries use a socket with a scrolled
metal connector emerging from the side which mates with that strip. This ensures that the Schuko
can be used in most mainland European countries.

Important

The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: earth
Blue: neutral
Brown: live
The colours of the wires in the mains lead of this appliance might not correspond with the coloured
markings identifying the terminals in your plug. Proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is
marked "E", marked by the earth symbol or coloured green-and-yellow. The wire, which is coloured
blue, must be connected to the terminal, which is marked with the letter "N", or coloured black. the
wire which is coloured brown must be connected to the terminal which is marked with the letter "L"
or coloured red.

Starting Up

Main switch（optional）
Plug in the cabinet.
The display shows the actual cabinet temperature
Servicing
Make sure the appliance is switched off at the mains before service is performed on
electrical parts.
GB
Lock
8
Thermostat Display
P2M031STD - Ver.1.0