Publicité
Les langues disponibles
Les langues disponibles
Table 2
DROP 4.5
DROP 6
DROP 9
NB!
It is forbidden to use a non-heat-resistant cable with PVC isolation
as the power cable. The joint box must be waterproof and it must be
located up to 50 cm from the floor.
•
Open the cover of the heater's electrical box.
L1 L2 L3
N
3/N ~400V
•
Attach the power cable on the terminal block according to the
circuit diagram.
•
Close the cover.
•
Fix the cable on the output with a cable strap.
•
Install the heater on the wall frame.
Fittingthestones
Upon stacking the stones, one should monitor that the heating
elements are not bent and that there is a sufficient air circulation
around the heater elements.
•
The stones must be washed clean before laying.
•
Stack the stones sparsely between the heating elements. When
the stones have been stacked too close to each other, the heating
elements may overheat (= shorter useful life) and slow the heating of
the sauna.
6
Output
Elements
kW
4,5
6
8,5
1,5 / 2
Circuit Breaker
kW
1,5
3 × 10
2
3 × 10
3 × 16
Power cable
A
mm
5 × 1,5
5 × 1,5
5 × 2,5
2
Publicité
