QEP 83200Q Manuel D'utilisation page 13

5 . From underneath the saw, directly below the
rip fence, there are two ¼" bolts located under
the left rip fence and 2 bolts under the right rip
fence . Loosen both bolts for the rip fence that
you are adjusting . (See Images E & F)
ImAgE E
6 . Once the screws are loose, easily slide the rip
fence above, allowing you to close the gap
between the square and the rip fence . When
the square is flush against the rip fence
re-tighten the two ¼" bolts from the side you
are adjusting . If necessary, repeat the same
steps for the other side . (See Images G & H)
ImAgE g
ImAgE h
¼
" bolts
ImAgE f
No More
Gap
7 . Once both rip fences are secured in place
slide the extruded aluminum angle bar
firmly against both rip fences and tighten in
place for additional support .
Q.e.P. CUStOmer SerViCe:
1-866-435-8665
– 11 –