Conrad REELY SKY 450 ARF QC09 Notice D'emploi page 51

• Never switch off the remote control (transmitter) while the model is in use. After landing, always disconnect the flight
battery first or switch off the model. Only then may the remote control be switched off.
• In case of a defect or a malfunction, remove the problem before using the model again.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.
• In the case of a severe crash (e.g. from a high altitude). the electric gyro sensors can be damaged and/or misadjusted.
Therefore, full functionality must be tested before flying again without fail! We recommend adjustment to the neutral
position.
• In the event of a crash, the throttle should be immediately reduced to zero. Rotating rotors may be damaged if they
come into contact with obstacles e.g. overcharging. Before flying again, these should be checked for possible tears
or breakages!
• To avoid damage to the QuadroCopter through crashing due to low voltage of the rechargeable battery through total
discharge, we recommend that you respect the low voltage light signals without fail. As the integrated LEDs only
flash in one direction, we also recommend installing the LiPo Saver (Conrad item no. 230327). The LiPo saver
warns you of impending low voltage by light signal. Place the LiPo Saver on the appropriate place of the Quadro-
Copter.
51