Axis Q8685-E Guide D'installation page 35

Important
These instructions apply only to device firmware earlier than v8.40.
1. Go to the product's web page.
2. Go to Settings > System Options > Maintenance and click Default.
3. Wait for the camera to reset.
4. Go to the product's web page.
5. Go to Setup > PTZ > Advanced > Device > Extended Driver Specific Settings for
Video Source 1.
6. Go to Camera housing configuration and select Inverted.
7. Click Save.
Important
These instructions apply only to device firmware v8.40 or later.
1. Go to the product's web page.
2. Go to Settings > System > Maintenance and click Default.
3. Wait for the camera to reset.
4. Go to the product's web page.
5. Go to Settings > System > Plain Config > PTZ.
6. Go to Camera housing configuration and select Inverted.
7. Click Save.
Install the illuminator kit (default installation)
WARNING
• Risk of electric shock. Make sure the power supply is disconnected.
• Emission of infrared light (risk group 2) from the illuminators can be harmful for eyes.
Pay attention to the provided indications. To reduce the risk of eye damage, avoid eye
exposure, and use appropriate shielding or eye protection at distances of less than
1.5 m (4.9 ft).
CAUTION
During normal operation, the surface of the illuminator can reach high temperatures. Do
not allow direct contact and position the appliance where it is inaccessible to unauthorized
personnel. Before touching, switch off the illuminator and allow to cool for a minimum
period of 10 minutes.
AXIS Q8685-E PTZ Network Camera
35
EN