Axis Q8685-E Guide D'installation page 23

1
Power cable (not included)
2
Strain relief
3
Grounding screw
4
Grounding braid (not included)
5
Bottom cable hole
1. Install the optional conduit adapters (not included).
2. Connect the grounding braid to the grounding screw.
3. Insert the power cable, I/O cable and network cable through the hole in the base unit as
shown in the illustration above. Alternatively insert them through the bottom cable hole.
4. Insert the power cable through the strain relief with a distance of 530 mm (21 in) from
the strain relief to the end of the cable.
AXIS Q8685-E PTZ Network Camera
23
EN