Taurus Alpatec R750 Mode D'emploi page 11

duration of the appliance's useful life and could become
unsafe to use.
- Then dry all parts before its assembly and storage.
Cleaning the appliance:
- In order to avoid the creation of odours and ensure the
unit works properly, it must be cleaned internally once
every two weeks.
- Remove the front panel by loosening the two
attachment pins and lifting the panel upwards, off the
2 upper attachment points. Remove the filter and the
honeycomb filter from the unit.
- Wash the filter in warm water with a mild, soapy
solution; use a soft brush if necessary. Rinse with clean
water and leave to dry.
- Wash the honeycomb filter with clean water and a soft
brush if necessary. Leave to dry.
- Empty the water tank and clean with water, a mild
soapy solution and a soft brush if necessary. Rinse with
clean water and leave to dry.
- At the end of the season, store the cleaned and dried
heater in the original packaging if possible. Store it
upright in a cool, dry and dust-free place.
Front panel
R750-Notice.indb 11
Anomalies and repair
- Take the appliance to an authorised technical support
service if product is damaged or other problems arise.
Do not attempt to disassemble or repair the appliance
yourself as this may be dangerous.
- If any anomaly is detected, check the following table:
Anomaly Causes
The device does - No electricity.
not work
- Is the ON/OFF but-
ton pressed in?
- An internal compo-
nent is broken
The unit will - ON/OFF button not
not switch off pressed in
- An internal
component is broken
Peculiar sounds - Something is not
positioned correctly
inside the machine
- A swivel wheel is
broken/missing.
- Ther is an internal
problem
The unit humidi- - Filters are blocked
fies too much or by dirt
too little - Technical
breakdown
The following information details the features related
to ecodesign:
Maximum fan flow rate (F): 10,39 m³/min
Fan power input(P): 46 W
Service value (SV) (according to IEC 60879): 0,23 (m ³/min)/W
Standby power consumption (PSB): 0,47 W
Fan sound power level (LWA): 56 dB(A)
Maximum air velocity( c ): 2,97 meters/sec
Back cover
Filter
Honeycomb-filter
Solutions
- Check to ensure the
plug is in the socket
and that the socket
is live
- Press the on/off
button
- Consult the after
sales service
- Press the on/off
button.
- Consult the after
sales service
- Remove the
filter and the water
reservoir and install
it correctly
- Consult the after
sales service
- Clean the filters.
- Consult the after
sales service
14/12/2015 10:06