Designated Use - Abicor Binzel PSB Mode D'emploi

PSB
1 Identification
1.1 CE marking
2 Safety

2.1 Designated use

The manual and automatic cutting torches of the PSB series are used in
industry and the trade exclusively for plasma cutting or gouging with
compressed air as the plasma and cooling gas. They consist of the torch neck
with equipment parts and wear parts, handle and cable assembly with direct
connector or central connector. They conform to EN 60 974-7 and are not
considered devices having their own functions. For operation, a cutting power
source is required. The cutting torches may only be operated using original
ABICOR BINZEL spare parts.
This device fulfils the requirements of the relevant EU directives.
Conformity is confirmed by the CE marking on the device.
The attached safety instructions must be observed.
• The device described in these instructions may be used only for the
purpose described in these instructions in the manner described. In doing
so, observe the operating, maintenance and servicing conditions.
• Any other use is considered contrary to the designated use.
• Unauthorized conversions or power increase modifications are not
allowed.
1 Identification
EN - 3