brennenstuhl MULTI ADM 3000 MA Mode D'emploi page 10

Les langues disponibles

Operating instructions

Insert the charged 18 volt battery into the battery holder from behind (Fig. 1e) until you feel

it click into the end position. To remove the battery, press the battery release button and pull

the battery to the side out of the battery holder. Then close the cover again (Fig. 1f).

To ensure IP65 (dust and splash-proof ), the spotlight must only be operated with the

battery cover properly closed.

If the device is not used for a longer period of time, remove the rechargeable battery.

The floodlight can also be operated without battery cover up to 12 Ah rechargeable

batteries; in this case, the IP class will, however, be reduced to IP20 and the floodlight may

only be operated in a dry environment. To do so, open the battery cover locking (Fig. 1a).

Afterwards, remove the battery cover.

CHARGING THE RECHARGEABLE BATTERY

Only use one of the manufacturer's original charging device: Bosch, Dewalt, Festool, Flex,

Makita, Metabo (CAS), Milwaukee.

TRIPOD MOUNTING

By means of the holes in the holding bracket, the floodlight can be mounted on a

Brennenstuhl tripod.

If two floodlights are mounted, the accessory crossbar "CB 70 1172640059" is required.

SCOPE OF DELIVERY

Floodlight, 6 multi adapters: Bosch, Festool, Flex, Makita, Metabo, Milwaukee/Dewalt,

Adapter bag.

ACCESSORIES

Suitable accessories are available on our homepage www.brennenstuhl.com.

CLEANING

Remove the rechargeable battery before cleaning.

Do not use solvents, caustic cleaning agents or similar products.

Only use a dry or slightly moistened cloth for cleaning.

MAINTENANCE

ATTENTION: The LED lamp does not contain components that require maintenance.

The light source of this lamp cannot be replaced. If the light source has reached the end of

its service life, the entire lamp has to be replaced. The lamp may not be opened.

013922 BA_MULTI ADM 3000 MA 0533958.indd 10

MULTI ADM 3000 MA

26.04.22 11:57