Cardin FM S508 Mode D'emploi page 15

SYSTEM MANAGEMENT OPERATIONS
• Memorizing a channel code
• Deleting a channel code (via an associated transmitter)
• Deleting the entire code memory (users)
• Memorizing more transmitters by using a previously memorized transmitters
Attention! Before memorising the transmitters for the first time remember to cancel the entire
memory content.
• Memorizing a channel code
- Move the transmitter near to the receiver.
- Press and hold down the MEMO button on the receiver and the LED LGC will flash slowly
- Press the button (channel) you wish to memorize on the transmitter.
- The LED LGC on the receiver will flash rapidly.
- Press the button (channel) you wish to memorize on the transmitter a second time. The LED LGC on the
receiver will glow continuously. After a few moments led LGC will switch off.
- Release the MEMO button. End of operation.
• Deleting a channel code (via an associated transmitter)
- Move the transmitter near to the receiver.
- Press and hold down the DEL button on the receiver and the LED LGC will flash rapidly.
- Press the button (channel) you wish to delete on the transmitter.
- The LED LGC on the receiver will glow red continuously. After a few moments Led LGC will switch off.
- Release the DEL button. End of operation.
• Deleting the entire code memory content (users)
- Press and hold down the MEMO and DEL buttons for more than 4 seconds on the receiver.
- LED LGC will remain lit for the entire duration of the deletion, which lasts for about 3 seconds
- LED LGC will flash for a few moments and then switch off.
- Release the buttons. End of operation.
15