Cardin FM S508 Mode D'emploi page 12

Transmitters
The transmitter is pre-coded and is fitted with an integrated circuit which is programmed in the factory
with a unique identification number. All the code parameters are contained in this integrated circuit. The
transmitter has an automatic shut down mechanism which cuts in after at least 20 seconds of continuous
use (this limits battery consumption).
Key block function
• A key block function has been added to protect the appliance from
accidental activation;
- to activate the functionpressand holddown "MR"for 8 secondsuntil
the orange led starts flashing, at this point to activate a command
you will need to press the required key three times consecutively;
- to reset the function to standard operation standard press and hold
down "MR" for 8 seconds until the orange led starts flashing.
Receivers
Warning! The receivers must only be powered by a safety power pack. The use of non-safety power
packs could provoke damage to the system.
FASTENING THE OUTDOOR RECEIVER IP55 (fig. 4, pag. 45)
Open the four fastening holes as shown in the drawing using a screwdriver of similar tool. Trace the four wall
fastening points using the container as a template and then drill the holes (det. 3-4). Fasten the container
using four self-tapping screws M4,8 (det. 5). Once the container has been fastened insert the screw covers.
remove the cable clamp covers and affix the two cable clamps as shown in detail 6.
Outdoor receivers (fig. 5)
The outdoor receiver is fitted with a 13-way terminal board and has a 12/24V ac-dc electrical connection
between binding posts 1-2.
12
1
2
MR