Cardin FM S508 Mode D'emploi page 14

Mini receivers IP20 (fig. 7)
The mini receiver is fitted with a 10-way terminal board with an electrical connection of 12/24V ac-dc between
binding posts 7-8. The receiver cards are fitted with two relays the outputs of which are marked CH1 (normally
open/normally closed contact) and CH2 (normally open/normally closed contact). To associate the channels
CHA, CHB, CHC, CHD on the transmitters to the relays CH1 and CH2 use the jumpers J1 located on the
circuit board (e.g. fig. 7 - CHA = CH1 and CHB = CH2).
The channel relays can be set using the jumpers SEL CH1 and SEL CH2 as follows:
- ON/OFF relay =
- Impulsive relay =
To change the relay function mode (from impulsive to ON/OFF and the other way round) the receiver
must be switched off and restarted.
Receiver code memory module
The codes are stored in a non-volatile EEPROM memory module.
The receiver is designed to manage up to 1000 users (1000 transmitters) with the possibility of memorising
and cancelling each individual user.
For each transmitter it is possible to memorize a maximum of 4 functions: A - B – C – D.
The memorized codes are maintained in this module even in the absence of power for an unlimited period
of time.
Indications on the receivers
Red Led LGC - user management
- Flashing slowly: memorising a single user
- Flashing rapidly: cancelling a single user
- Continuously lit: memory full
Jumper inserted
Jumper not inserted
Green Led LS - appliance "STATUS" LED
- Continuously lit: power on
- Flashing: no memory module present
14