Publicité
Les langues disponibles
Les langues disponibles
Use
Ice maker instructions
WARNING!
▶
Connect to potable water supply only.
▶
Connecting the water line must only be installed by a qualified plumber and in ac-
cordance with local legislation and regulations governing water quality.
Notice
This water line installation is not covered by the appliance warranty.
Connecting water to the appliance
1.
Remove the rubber plug (1) from the water inlet
valve.
2. Firmly push the water tube onto the water inlet
valve and tighten up the collar nut. This water
pipe needs to be cut from the middle and used,
and the other section is used as a spare part.
Connecting to the water tap
This feature is only available on some models.
1. Push the water tube into the hole of the tap connec-
tor supplied in the accessories. The pipe should be held
firmly whilst the connector is pushed onto the pipe.
2. Ensure that the rubber washer is fitted to the inside of
the tap connector before screwing it onto the tap.
▶
A separate connector or adaptor may need to be pur-
chased if your tap fitting does not match the thread
size of the connector provided.
Checking the Water Connection
This feature is only available on some models.
▶
Turn on the water supply and switch on the appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
▶
Press and hold the 3Sec.Filter Reset button for three seconds. The new water filter
has been activated.
▶
Place a cup under the water dispenser to verify that water is flowing through the
appliance.
▶
Check the connecting tube and joints for leaks once again.
24
GB
①
Publicité
