Publicité
Les langues disponibles
Les langues disponibles
Operating an iPod directly
— Passenger control
You can operate an iPod connected to the dock
connector directly.
1
During playback, press and hold
(MODE).
"Mode iPod" appears and you will be able to
operate the iPod directly.
To exit the passenger control
Press and hold (MODE).
Then "Mode Audio" will appear and the play
mode will change to "Resuming Mode."
Notes
• The volume can be adjusted only by the unit.
• If this mode is canceled, the repeat setting will be
turned off.
Other functions
Changing the sound settings
Adjusting the sound
characteristics
1
Press the control dial.
2
Rotate the control dial until the
desired menu item appears, then
press it.
Depending on the setting, by rotating the
control dial again, further parameters can be
set.
3
Rotate the control dial to select the
setting, then press it.
4
Press
(BACK).
The setting is complete and the display
returns to normal play/reception mode.
The following items can be set:
EQ3 Parametric Preset
Selects an equalizer curve from 7 music types.
EQ3 Parametric Tune*
Custom equalizer settings.
Subwoofer Tune & LPF
Phase
Selects the phase (effective only when LPF is
on): "Normal," "Reverse."
FREQ
Selects the subwoofer cut-off frequency:
"80Hz," "100Hz," "120Hz," "140Hz," "160Hz,"
"OFF."
Level
Adjusts the subwoofer volume: "+10dB" –
"0dB" – "–10dB."
("– ∞" is displayed at the lowest setting.)
HPF & Speaker Select
Speaker
Selects the Speaker: "All," "Front", or "Rear."
FREQ
Selects the cut-off frequency: "OFF," "80Hz,"
"100Hz," "120Hz," "140Hz," "160Hz."
DSO (Dynamic Soundstage Organizer)
Creates a more ambient sound field.
To select the DSO mode: "1," "2," "3," or "off."
The larger the number, the more enhanced the
effect.
continue to next page t
1
17
Publicité
