Publicité
Les langues disponibles
Les langues disponibles
10. IMPORTANT: Make certain the spindle taper (Q)
Fig. 15, and tapered hole in chuck (R) are clean and
free of any grease, lacquer or rust preventive coatings.
NOTE: Household oven cleaner can effectively remove
any sub-stance from the spindle and chuck; however,
carefully follow the manufacturer's safety rules
concerning its use.
11. IMPORTANT: Open the chuck jaws as wide as
possible by turning the chuck sleeve (S) Fig. 16.
12. Holding chuck on taper of spindle, tap with a soft tip
hammer (T) or a block of wood and hammer to set
chuck, as shown in Fig. 16. IMPORTANT: To avoid
damage to the chuck, NEVER drive the chuck onto the
spindle with a metal hammer.
FASTENING DRILL PRESS TO SUPPORTING
SURFACE
If during operation there is any tendency for the
machine to tip over, slide or walk on the supporting
surface, the machine base must be secured to the
supporting surface with a M8x1.25x125mm carriage
head screw, 8.5mm flat washer, 8.5mm lock washer,
M8x1.25 hex nut, through the two holes (A) Fig. 17,
located in the machine base.
OPERATING CONTROLS AND ADJUSTMENTS
STARTING AND STOPPING DRILL PRESS
The switch (A) Fig. 18, is located on the front of the drill
press head. To turn the drill press "ON" move the
switch up to the "ON" position. To turn the drill press
"OFF" move the switch down to the "OFF" position.
T
A
A
10
Q
R
Fig. 15
S
Fig. 16
Fig. 17
Fig. 18
Publicité
