SOLAC PV2013 Mode D'emploi page 13

ties.
Swing the iron gently from side to side. Steam
and water will come out of the holes in the iron,
flushing out dirt and impurities (fig. 6-7).
Be careful when performing this operation,
as the water and steam are very hot and can
cause burns.
7 Place the iron in the vertical position and wait
for it to cool completely.
8. Wipe the soleplate with a damp cloth.
+ Remember that damage caused by the effects
of limescale is not covered in the warranty.
This symbol means that it is important to
read the operating instructions.
This symbols means that user must to con-
PV2013_plancha.indd 13
sult instructions thoroughly before use.
This symbol indicates that the appliance
should not be covered.
This symbol indicates that the surface may
heat up during use.
This appliance complies with Directive 2014/35/
EU on Low Voltage, Directive 2014/30/EU
on Electromagnetic Compatibility, Directive
2011/65/EU on the restrictions of the use of
certain hazardous substances in electrical and
electronic equipment and Directive 2009/125/
EC on the eco-design requirements for ener-
gy-related products.
EN
15/7/16 15:59