Publicité
Les langues disponibles
Les langues disponibles
ON
MENU
PRE-
STANDBY
A B C
HEAT
Manual Microwave Entry
Microwave function cooks using microwave
energy. Set cooking time and power levels.
To prevent personal injury, handle
utensils, racks, and door with
care. Utensils, racks, and door
may become hot during operation.
Operating Microwave Function
1. Verify oven shows "READY" in display.
• If oven display shows "STANDBY",
press ON/STANDBY pad.
• If "R" in "READY" is not flashing, open
and close oven door.
• Preheat temperature and "PREHEAT"
appear in display if oven is in preheat
mode.
MENU A
READY
Current Menu
Status
2. Press MICROWAVE pad to select microwave
cooking function. Colon (:) in cooking time
flashes.
Cooking Time Microwave Power Level
2:00
MICRO HI
MANUAL
STAGE 1
Current Stage
3. Press arrow pads to add or subtract cooking
time.
4. Press OPTION pad.
5. Press arrow pads to increase or decrease
microwave power level. For example, press
the down arrow once for "90%". "HI" is 100
percent microwave power level.
• If no additional cooking stages are
required, go to step 7.
MICROWAVE CONVECTION COMBINATION
Caution
OPTION
6. Press OPTION pad. Oven display shows
"PROGRAMMING STAGE (2–4)" for 2
seconds, and then display shown below.
• Repeat steps 3–7 if additional cooking
stages are required. See Oven
Operation section under Cooking for
explanation of stages.
SELECT COOK FUNCTION
MANUAL
STAGE 2
7. Open oven door, place food in oven, and
close door.
8. Press START pad. Total time for each
stage selected counts down. Oven stops
and signals at end of cooking sequence.
9. Remove food to avoid overcooking.
Pause or Cancel
1. Press STOP/RESET pad or open oven
door to pause cooking sequence.
2. Press STOP/RESET pad again to
cancel cooking sequence.
Summary of Microwave Entry
1. Verify oven display shows "READY".
2. Press MICROWAVE pad.
3. Press arrow pads to add or subtract cooking time.
4. Press OPTION pad.
5. Press arrow pads to increase or decrease
microwave power level.
6. Press OPTION pad. Repeat steps 2–7 for additional
stages.
7. Open oven door, place food in oven, and close door.
8. Press START pad.
9. Remove food.
13
START
1
2
3
4
5
6
7
8
STOP
RESET
Publicité
